Woods RD6000 Operator's Manual

24, PN-52886 (4/97)22 Remove input shaft (3) with bearing (8) from front cover (6). Remove bearing (8) from input shaft (3). Remove input bearing (9) by using a punch and hammer from outside the housing. Remove the input oil seal (20) by using a punch and hammer from outside the housing. Suppo…

22, PN-52886 (4/97)20 Identify the open side of the seal containing the spring. Lightly coat, with Permatex, the area of housing where seals seat. Install bottom seal with spring up toward center of housing. Place seal squarely on housing and select a piece of pipe or tubing with an OD that will …

15, 13PN-52886 (4/97) Uneven Terrain WARNING ! Do not operate on steep slopes. ! Do not stop, start or change directions suddenly on slopes. ! Use extreme care and reduce ground speed on slopes and rough terrain. ! Watch for hidden hazards on the ter- rain during operation. Pass diago…

32, PN-52886 (4/97)30 Rear Caster Wheel Installation (Figure 30) CM850 1/2” LOCKNUT CASTER WHEEL ASSEMBLY 1/2 x 1-3/4” BOLT Figure 30. Rear Caster Wheel Assembly Remove rear caster wheel assembly from shipping position and install as shown in Figure 30 using the same bolts and nuts. Repea…

39, 37PN-52886 (4/97) RD6000, RD7200 & RD8400 DRIVE SHAFT -- MALE HALF COMER (TRI--LOBE SHAFT) CD4993 11 END VIEW OF DRIVE SHAFT 10 6 1 2 3 5 7 9 8 4 2.4 1.42 Ref Part No No No Used Description 1 51848 1 Drive, Profile shield 40, 26.2, 1.38 SP 2 30912 1 Yoke 40, 1.38 QD (includes item #11) …

40, Woods RD6000 PN-52886 (4/97)38 BLADE & SPINDLE ASSEMBLY: RD6000 (SN--793932 AND PRIOR) & RD7200 (SN--688690 AND PRIOR) Ref Part No No Description 1 38042 5/8--18 UNF Hex jam nut 2 10378 1/4 NC x 1 Hex head cap screw GR5 3 38020 .679 x 1.41 Lockwasher 4 1985 1/4 Standard lockwasher 5 34425 H 3/4 Straight…