Wohler iAM-AUDIO-1 Operation & User’s Manual

58, Page 58 Next, check that the Sampling Frequency is 48 kHz and the Packet Time is 1ms or 250us. Check that the Firmware Version is the same as what is shown in Figure B- 3. Note: ALL Devices must use the same packet time, or sources or destinations may not be availa…

65, Wohler iAM-AUDIO-1 Page 65 Troubleshooting It can happen that the iAM-AUDIO Ravenna option doesn't immediately operate as expected. This can be the result of a variety of causes. Refer to Table C-2 for solutions to the problem. If after following the advice in the table, you still cannot r…

28, Page 28 Figure 4–1: Host IP Settings Close the control panel and reboot the host computer after making an IP address change to be sure the change takes effect. Either reconnect to the installed network or continue with this direct connection to access th…

59, Page 59 Controller Cloud The Cloud page shows any Ravenna devices on the given network, including any Wohler devices with the Ravenna option installed. After the configuration described in the previous section, the devices you have set up should now appear …

13, Page 13 Figure 2-5: Analog DB25 Input Connections 13. Analog Outputs: These male XLR connectors provide two balanced analog outputs: Left and Right . The source of these signals is the mix of audio as monitored by the internal speakers and is adjusted by the Volume contr…

36, Page 36 Configuration – Named Presets Use this page to create or edit Preset names. Use unique names that will make it easy for an operator to determine which Preset to select. Click Save to store the names you enter. Figure 4–8: Save Preset …