Vacon 100X series Installation, Technical And Maintenance Manual

6, 1 vacon • 4 Safety Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/ 1. SAFETY This manual contains clearly marked warning information which is intended for your personal safe- ty and to avoid any unintentional damage to the product or connected appliance…

18, 2 vacon • 16 Receipt of delivery Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/ 2.1 Type designation code VACON ® type designation code is formed of a nine-segment code and optional +codes. Each seg- ment of the type designation code uniquely corresponds to the p…

101, Options vacon • 99 Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/ 8 50 1050 AI low fault At least one of the available analogue input signals has gone below 50% of the defined minimum signal range. Control cable is broken or loose. Signal source has failed. Change the…

82, Vacon 100X series 8 vacon • 80 Options Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/ Figure 58. Keypad connected to the drive. 2 • Connect and fix the cable to the enclosure of the drive and hold the keypad to the wall. …

8, 1 vacon • 6 Safety Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/ Only spare parts delivered by VACON ® can be used. At power-up or fault reset, the motor will start immediately if the start signal is active, (unless the pulse control for Start/Stop logic has b…

30, 4 vacon • 28 Power cabling Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/ 4. POWER CABLING The mains cables are connected to terminals L1, L2 and L3 and the motor cables to terminals marked with U, V and W. See principal connection diagram in Figure 17. See also Table 12…