ROBAND ST500A Operating Instructions Manual

6, Page: 3 INSTALLATION Remove all the packaging materials, tape and all protective plastic from the machine. Clean off any glue residue left over from the protective plastic using methylated spirit. Place the toaster on a firm level surface in the required positio…

3, CONTENTS INTRODUCTION ..................................................................................................... 1 GENERAL PRECAUTIONS ..................................................................................... 1 PACKAGE CONTENTS .............................…

15, Page: 12 TROUBLESHOOTING Check all the following points before contacting a service agent. If the Toaster does not start:  The power point is not faulty.  The machine is plugged in correctly and the power switched on.  The Lid is in the closed position. …

7, ROBAND ST500A Page: 4 NOTE: The toaster is not designed to be installed on top of other cooking equipment. Remove the crumb tray packaging and insert the crumb tray into the toaster. If it has been removed for cleaning, please ensure that it has been replaced prior to …

9, Page: 6 WARM UP CYCLE After switching on, the toaster will begin its Warm-Up Cycle. During warm up, the elements will be powered at 100% and the amber pilot light will flash quickly. The conveyor will switch on after 3 minutes of warm up. The toaster takes about 10 …

11, Page: 8 FAULT MODES In the event of a fault, the machine will enter Fault Mode. During fault mode, power to the elements and the conveyor will be shut down until the fault is rectified. Some lights will flash depending on the fault. Please check …