Tescom TC-3000C Operating Manual

106, Tescom TC-3000C 5.3 Reference Guide using RS-232C commands 106 READ:SYS:DUT:BAUDRATE? Description This command reads baud rate depending on the type of HCI transport layer of a DUT. CONF:SYS:DUT:BAUDRATE <Value> Description This command writes baud rate depending on …

214, Appendix B. RF Test Cases of the TC-3000C 214 supports power control, then the tester will consecutively send LMP_incr_power_req requests until the LMP_max_power response would be received from the DUT. The time delay between two consequential LMP_incr_power_req requests dep…

216, Appendix B. RF Test Cases of the TC-3000C 216 selected then the displayed value of the parameter is ignored and the value according to RF Test Specification [1] is assigned automatically. Requirement to Initial Condition of a DUT If the DUT can be controlled through HCI, the DUT mus…

179, 5.7 Reference Guide for using DLL 179 Syntax unsigned long open_remote_hci_tl(void); Return Value The return value of this function will be zero if the function is successful. Otherwise, the return value will be an error code. Parameter void close_remote_hci_tl De…

49, 3.5 Operation Procedure (Measurement/Measurement2) 49 3.5 Operation Procedure (Measurement/Measurement2) This chapter describes the operation procedure of RF Measurement. When you select the measurement screen or run the test cases, the TC-3000C makes a con…

249, Appendix C. The list of Save/Recall parameters 249 Location in GUI Parameters Initial Values Upper Freq(Hz) 3500 CH1 Freq(Hz) 1000 CH2 Freq(Hz) 400 CH1 level(dBm0) -3 CH2 level(dBm0) -3 Audio Spec Tone Freq 1000 Tone level -10 …