Nihon Kohden ZM-920PA Operation & User’s Manual

11, 2 Operator’s Manual ZM-920PA/921PA/930PA/931PA WARNING The following actions must be taken to properly receive the transmitter signal of the correct patient on the receiving instrument. Otherwise, there may be signal loss or signals may mix causing a serious accident, such a…

64, Operator’s Manual ZM-920PA/921PA/930PA/931PA 55 Changing the Transmitter Channel The transmitter channel can be changed by the QI-901PK Channel Writer. To change the channel number, refer to the channel writer manual. WARNING The following actions must be taken to properly recei…

97, 88 Operator’s Manual ZM-920PA/921PA/930PA/931PA Transmission frequency (MHz) Channel No. Transmission frequency (MHz) Channel No. Transmission frequency (MHz) Channel No. 1429.2375 E679 1429.6125 E709 1429.9875 E739 1429.2500 E680 1429.6250 E710 1430.0000 E740 1429.2625 …

67, 58 Operator’s Manual ZM-920PA/921PA/930PA/931PA Disinfection CAUTION • Do not immerse the electrode lead connector in liquid. • Do not disinfect with hypochlorous acid. • Use the recommended concentration. Wipe the outside surface of the transmitter and electrode lead with a non-ab…

63, Nihon Kohden ZM-920PA 54 Operator’s Manual ZM-920PA/921PA/930PA/931PA Problem Cause Countermeasure 3 electrode leads are properly attached to the patient but LEDs light. The transmitter is xed to 6 lead monitoring. Turn off and on the transmitter power. Heart rate of the rate of the patient who is…

34, Operator’s Manual ZM-920PA/921PA/930PA/931PA 25 ECG Monitoring When 6 leads are used on this transmitter, up to 8 lead (I, II, III, aVR, aVL, aVF, Va and Vb) of ECG waveforms can be displayed on the receiving monitor. The heart rate is also measured. When 3 leads are used, …