NOYAFA NF-300 Instruction Manual

11, NOYAFA NOYAFA USB BNC Setup 17 Unit : When moving cursor to “Unit” item, choose “meter”,The following interface will be shown: “ ” Note: Setup of the unit of inch and yard is just the same as that of meter. Choose English, then the screen will …

8, 11 Test result 5: BNC cable length test If to insert one end of the BNC cable to be tested into “BNC” port of the main tester, the other end is an open circuit, and then select length test, and then press “ENTER” key to perform length test with the equipment, the following interface wil…

9, 1.Tracing cable (RJ45/RJ11 Cable) which is connected to switch or router. Insert the cable into port RJ11/ RJ45 (S), Press the testing key of receiver, “Power” will be lighted, then hold the receiver close to the cables, when the probe gets close to the targeted one, you can hear c…

4, 03 (5).Detecting cable types STP/UTP 5E, 6E network cable, telephone cable, coaxial cable, USB cable and common metal wires connected with alligator clip. (6).Operating environment temperature/humidity -10 ~ +60 /20% ~ 70%;℃ ℃ (7).Testing device interface Main unit: RJ45 (M), RJ45 (…

7, 09 Special use: can test line sequence of the connecting cables In case of exchanger power-on, the main unit Take network cable as an example: one end of the cable is connected with “MAIN” interface of the main unit, and other end is connected with exchanger interface. …

6, NOYAFA NF-300 07 Note: Because network cable is made of pair cores, if there is open circuit, it will show faults in pairs, just as above "4" &" 5". it means either "4" pin or "5" pin exsits an open circuit, or both "4" and "5" exsit an open circ…