Data: UPD 10th October 2023
Lorex LW3211 SERIES Security Camera PDF Quick Start Manual (Updated: Tuesday 10th of October 2023 09:54:15 PM)
Rating: 4.3 (rated by 53 users)
Compatible devices: C861CF Series, LNE3142 SERIES, SG6130, SG7524, DMC2161, SG6182S, LW2175R SERIES, VANTAGE LNB2151 Series.
Recommended Documentation:
Text Version of Lorex LW3211 SERIES Security Camera Manual (Summary of Contents)
(Ocr-Read of Document's Main Page, UPD: 10 October 2023)
720P WIRELESS DIGITAL SECURITY CAMERA
LW3211 SERIES
QUICK START GUIDE
A. Installing the Camera
B. Installing the Receiver C. Connecting to an MPX/HD DVR
Connect the BNC cable to your MPX/HD
DVR’s** video input.
Mount the camera to the wall or ceiling using the
included screws. Use the included anchors as needed.
1
2
Connect the camera power adapter
to the camera. Connect power adapter
to a power outlet.
Before you permanently install your camera:
ATTENTION: Make
sure to first connect and
power on the camera before
powering on the receiver.
Getting Started
3
Connect the receiver power adapter to
the receiver. Connect the power adapter
to a power outlet.
This system comes with the
following components:
1x wireless camera
1x wireless receiver
1x antenna for camera
1x antenna for receiver
2x power adapters (for camera and receiver)
1x camera mounting kit
1x receiver mounting kit
Installation Tips
Plan where and how it will be positioned.
Determine where you will route the cable that
connects the camera to the power adapter.
Verify the camera’s performance by observing
the image on a monitor when the camera is posi-
tioned where it will be permanently installed.
Avoid installing the camera in a location where the
wireless signal must pass through cement, concrete,
or metal structures. This will reduce the transmission
range.
Power cables are only weatherproof when fully inserted at
the connection point. Power cables should not be submerged
in water.
For outdoor use, installation in a sheltered location is recommended.
NOTE: It is not recommended to install more than
3 digital wireless security cameras in the same
environment to maintain optimal video frame rate
performance.
Installing Multiple Wireless
Cameras
When installing multiple digital wireless security
cameras in the same environment, maintain at least
4” / 10cm between the receivers to optimize camera
performance.
NOTE: If you run the
cables along the wall /
ceiling, you must run the
cable through the cable
notch on the base. This
will keep the camera
base flush to the wall /
ceiling when mounted.
Outdoor Receiver Installation
4
Remove protective film from the
camera lens.
BNC video
Use the double-sided
tape to securely attach
the receiver to a flat
surface. OR secure the
receiver using the included
mounting screws.
OPTIONAL:
OPTIONAL:
Adjust the angle of the camera until the desired
view is set. Tighten the screws and the adjustment
ring to secure the camera position.
A
A) Turn the adjustment
ring to tighten / loosen
the stand connection.
B
B) Loosen the lower
screw with the Allen
key to adjust the cam-
era’s vertical position.
C
C) Loosen the upper
screw with the Allen
key to rotate the
camera housing.
LW3211_SERIES_QSG_EN_R1
For support and instructions:
Visit www.lorextechnology.com
Search your product’s model number
Select your product from the search results Click on the Downloads tab
1
2
3
4
NOTE: The camera and receiver have al-
ready been paired out of the box. If for some
reason the pairing is lost, follow these steps
to pair up the camera and receiver.
1
Make sure that the camera
and receiver are both
powered up and all antennas
properly attached.
2
Press the PAIR button
on the receiver.
Press the PAIR button on the back of the
camera within 30 seconds of pressing the
PAIR button on the receiver. If succesful,
live video from the camera will appear on the
monitor.
3
Pair Button
**720p cameras are compatible with Lorex’s 720p & 1080p HD DVR recorders only.
Wireless
receiver
Mounting
screws
MPX/HD DVR
BNC cable
Power adapter
If mounting the receiver outdoors, refer to the example below. If
installing the receiver indoors, proceed to “Connecting to an
MPX/HD DVR“.
1
2
3
*Compatible camera extension cable CB60URB available at www.lorextechnology.com.
Extend the cable run of
your video cable and power
adapter up to 60ft with a
compatible extension cable*.
Recommended:
SM3547R, PALM m500, XOOM 2 series, VCD-102K
SND-3080CF, DS-2CD876BF, Nexus 7000 Series, VFD4V9Me, ELVOX 46512.036.01
-
flir.com/security/proCap housingRJ45 plugOuter sealInner sealCap-sealing nutEthernet connectorMODEL: N243BW4 SERIESQUICK START GUIDEEnglish Version 1.0FLIR Systems, Inc., Copyright © 2016 As our products are subject to continuous improvement, FLIR Systems Inc. reserves the right to modify ...
Model & Doc Type: N243BW4 SERIES 2
-
Ultra high sensitivity Day/Night Camera with ABF (Auto Back Focus) for 24 hours a day surveillance Key Features• 1/2 inch CCD delivers high sensitivity high quality picture.• High resolution: 540 TV lines typical / 520 TV lines minimum (Color HIGH mode), 480 TV lines minimum (Co ...
Model & Doc Type: WVCL930 - COLOR CCTV CAMERA 2
-
Amcrest IP3M-941S/ IP3M-941B / IP3M-941W 3MP ProHD Indoor Wi-Fi Camera User Manual Version 1.0.4 ...
Model & Doc Type: IP3M-941S 75
-
QUICK START GUIDEFor a full explanation of all features and instructions, please refer to the User’s Guide.1. How to register your Camera to Hubble accountMODELS:FOCUS73, FOCUS73-21. Connect the Camera round plug to the Y-shaped Power/LAN cable connector. 2. Insert the power adapter plug into ...
Model & Doc Type: FOCUS73 3
Operating Impressions, Questions and Answers:
