Instruction Manual for Milwaukee pH600 Measuring Instruments, Test Equipment (1 pages)
Data: UPD 29th December 2023
Milwaukee pH600 Measuring Instruments, Test Equipment PDF Instruction Manual (Updated: Friday 29th of December 2023 04:20:16 PM)
Rating: 4.3 (rated by 89 users)
Compatible devices: M12 SUB-SCANNER 2291-20, MA871, MR100ATC, SM100, Smart Monitoring System SMS110, MA882, MI404, MW170 MAX.
Recommended Documentation:
Text Version of Milwaukee pH600 Measuring Instruments, Test Equipment Manual (Summary of Contents)
(Ocr-Read of Document's Main Page, UPD: 29 December 2023)
Instruction Manual
pH600
pH Tester
www.milwaukeetesters.com
Do not be
alarmed if
white crystal
appear around
the cap. This is
normal with pH
electrodes and they dissolve
when rinsed with water.
OPERATING:
Remove the protective cap
and turn the pH600 on.
Immerse it into solution up to
the maximum immersion
level.
Stir gently and wait until
the display stabilizes.
After use, rinse the electrode
with water to minimize
contamination.
Store the electrode with a
few drops of storage solution
(MA9015) or pH 7.01 buffer
solution in the protective
cap.
Always replace the
protective cap after use.
DO NOT USE DISTILLED
OR DEIONIZED WATER
FOR STORAGE
PURPOSES
Large differences in pH
readings (± 0.5 pH) could be
due to lack of calibration, dry
electrode or rundown
batteries.
The calibration procedure is
very simple and fast.
CALIBRATION:
Immerse the tester
up to the maximum
level in pH 7 buffer
(M10007).
Allow the reading to
stabilize and using a
small screwdriver turn the
pH 7 Calibration Trimmer
placed on the back of the
tester to read 7.0.
Calibration is now complete!
ALWAYS USE FRESH
BUFFERS FOR
CALIBRATION
When the pH600
cannot be switched on
or the display fades,
pull out the battery
compartment and
replace all three 1,5V
batteries, paying attention to
their polarity.
BATTERY
REPLACEMENT:
Batteries should only be
replaced in a non-hazardous
area using the battery types
specified in this instruction
manual.
Before using this product, make sure that it is
entirely suitbale for the environment in which
it is used. Operation of this instrument in
residential area could cause unacceptable
interferences to radio and TV equipments,
requiring the operator to take all necessary
steps to correct interferences.
RECOMMENDATIONS
FOR USERS:
The glass bub at the end of the pH electrode
is sensitive to electrostatic discharge. Avoid
touching this glass bulb at all times. During
operation of instrument, ESD wrist straps
should be worn to avoid possible damage to
the pH by electrostatic discharge. Any
variation introduced by the user to the
supplied equipment may degrade the
istruments EMC performance. To avoid
electrical shock, do not use this instrument
when voltages at the measurement surface
exceed 24 VAC or 60 VDC. To avoid
damages or burns, do not perform any
measurement in microwave ovens.
SPECIFICATIONS:
RANGE 0.0 to 14.0 pH
RESOLUTION 0.1 pH
TYPICAL EMC ±0.2 pH
ACCURACY (@20°C) ±0.1 pH
ENVIRONMENT 0 to 50°C
DEVIATION
BATTERIES LIFE 3 x 1,5V
alkaline
approax. up to
700 hours of
95% RH
use
DIMENSIONS 150x30x24 mm
WEIGHT 85g
Alsókikötö sor 11.
H-6726 Szeged - HUNGARY
Tel: +36 62 428 050
Fax: +36 62 428 051
[email protected]
Recommended:
hue, 915GVM-V, L41.., AUTOVIEW 2000 - AUTRE
320-KEL Series, OTDR, TBS2000 Series, PT Series, OCBT-1200
-
Technical DataFluke 1555 and 1550C Insulation Resistance TestersFluke insulation testers can now conduct the entire range of test voltages specified in IEEE 43-2000 with a best in class, 3 year warranty and CAT IV 600 V safety rating. With measurement storage and PC interface, the 1555 and 1 ...
Model & Doc Type: 1550C 2
-
User's Guide of BST-380 Battery System Tester 1 / 29 Congratulations on your purchase of the Silverado BST-380 Battery System Tester.Due to the product upgrade, tiny difference between the user manual and the device will not be further noticed. Take the device as ...
Model & Doc Type: BST-380 29
-
BATTEST2 - 1 - VELLEMAN BATTEST2 – MULTI-PURPOSE BATTERY TESTER WITH LCD DISPLAY 1. Introduction To all residents of the European Union Important environmental information about this product This symbol on the device or the package indicates that disposal of the device after its lifecycle ...
Model & Doc Type: BATTEST2 5
-
User’sManual4th Edition: October 2017All Rights Reserved. Copyright © 2008, Yokogawa Meters & Instruments Corporation, 2017, Yokogawa Test & Measurement CorporationPrinted in JapanStore this manual in an easily accessible place for quick reference.Safety PrecautionsThis product i ...
Model & Doc Type: 30032A 2
Operating Impressions, Questions and Answers:
