Kobold ZOK-ZxP Operating Manual

27, ZOK-E/-Z ZOK K14/0917 Page 27 7.9 Pulse Output and Status Output Pulse and status outputs are set to push-pull output type and provide an active digital signal with HIGH amplitude of about + Vs. Wiring for ZOK-Z3 with Supply option 3/6: …

56, ZOK-E/-Z Page 56 ZOK K14/0917 Outputs ZOK-x3* Pulse output (only-x3): transistor output, Push pull (PP), max. 300 mA, overload protection Analogue output (only –x3): 4-20 mA, 2-conductor loop operation or 3-wire operation (current source or sink) selectable by e…

58, ZOK-E/-Z Page 58 ZOK K14/0917 12. Ordering Details Example: ZOK-Z1 K M F 3 0 0) Model Electronics Housing Type Electrical connection/ Cable gland Input Power supply Options Special ZOK- Z1 = dual totaliser LCD Z2 4) = dosing unit LCD Z3 = rat…

41, Kobold ZOK-ZxP ZOK-E/-Z ZOK K14/0917 Page 41 Linearization Incorrect! Flowrate Ax negative slope! 10.3.5 Signal Input / Scaling A The correct scaling of the signal inputs is necessary for exact indication on the display. For this purpose, entering the pulse rate of the connected sensor…

40, ZOK-E/-Z Page 40 ZOK K14/0917 10.3.3 Signal Input / Input Timeout For the detection of input signals, the period duration of signal is determined within a measuring cycle i.e. Refresh time. However, if within the "refresh time" the input period is not complete i.e. if the input …