KMC Controls BAC-5051E Application Manual

16, l If the router is part of a system that uses the Internet, you will also need the public IP address and port. You will also need an HTML5 compliant browser, Ethernet cable, and a USB-A to USB-B micro cable or a 24 volt AC power source. Set up for configuration To configure the router, pl…

21, Device properties page The Device page identifies the BAC-5051E router for the Local Area Network (LAN). The IP Address, Subnet Mask, and Default Gateway values are supplied by the IT department system administrator. The Device page also identifies the router as a BACnet device and sets BACnet commu…

33, Remote Port Enter the port number of the remote PAD router. If port address translation (PAT) is used between the BAC-5051E router and the PAD or BBMD, contact the network system administrator for the correct public IP address. Other IProuting protocols l BACnet Broadcast Management Device routi…

6, BACnet routing BACnet IP–Two ports each of that can be set up for any of the following protocols: l Normal BACnet IP network routing l BACnet broadcast management device with network and port address translation l Foreign device registration with BACnet broadcast management devices (BB…

57, KMC Controls BAC-5051E 3 Make changes as needed and click Save when finished. Commanding and monitoring airflow Command the airflow to a specific level to make adjustments or measurements that require a steady airflow. 1 Log in and discover the VAV units as described in the steps 1-5 in VAV balancing. …

40, Status Icon Description Action Active The network is functioning correctly and capable of passing traffic. None required. Busy The amount of network traffic is high enough that no new traffic can be accepted. A temporary condition that does not require intervention. Down Gone The network i…