Newland NLS-EVK3030 Operation & User’s Manual

12, 9 Newland Auto-ID Tech. Co., Ltd. (Headquarters) 3F, Building A, No.1, Rujiang West Rd., Mawei, Fuzhou, Fujian, China 350015 Tel: +86 - (0) 591-83978605 Fax: +86 - (0) 591-83979216 E-mail: [email protected] Web: www.newlandaidc.com Newland Europe BV Rolweg 25,…

7, 4 Scan Engine Port Pinouts Pinout of J1 PIN Signal Function 1 BOOT It is connected to the DIP Switch on the EVK3030. If the switch is put in the BOOT position (see the picture in the “Parts Placement Layout” section), where this pin is set at low level, then the engine…

2, Revision History Version Description Date V1.0.0 Initial release. September 12, 2016 V1.0.1 Updated the pictures and relevant texts. October 12, 2017 V1.0.2 Updated the pictures and relevant texts. Added an example of cable installation (EM2096). February 28, 2018 …

5, Newland NLS-EVK3030 2 Part Description Note J1 TTL-232 scan engine port Connect J3 or J5 to a host device. J2 TTL-232/USB scan engine port Connect J3 or J4 or J5 to a host device. J3 RJ45 port Connect J1 or J2 to a scan engine using TTL-232 signals. EVK3030 converts TTL-232 signa…

6, 3 EVK3030 Block Diagram RS232 TTL232 USB USB TTL to RS232 (SP3232) TTL to USB (CP2102) RJ45 Port (J3) USB Port (J5) USB Port (J4) J1 (Hardware flow control) or J2 (No flow control) J2 1. Place a scan engine on EVK3030. 2. Connect the scan engine to E…

3, Table of Contents Revision History .......................................................................................................................................... - 2 - Introduction ..............................................................................................…