New England !VALON Assembly Instructions Manual

10, Main Support Beam Assembly 1 1 2 STEP FOUR 10 10 x 10 Flat Top Louvered Pergola At this stage, the columns should be properly installed as per the following illustration, with the columns 110” in. (279.4 cm) apart. Also, notice that the holes at the top of each post should be facin…

17, New England !VALON Louver Assembly 17 10 x 10 Flat Top Louvered Pergola Place twelve Steel Holder Brackets as shown below and care- fully lower the Louver assembly onto the steel brackets. Do not screw the Steel Holder Brackets in place at this point. Fasten the Short Louver Bar using two nuts as shown. Do not over…

14, Main Support Beam & Rafter Placement 14 10 x 10 Flat Top Louvered Pergola Fasten the Rafters to the Posts using the 4” screws provided (4 per post). Fasten a 4” screw at each intersection where the Beams and Rafters intersect as shown. 24 screws will be needed. 4 5 www.newenglanda…

19, Louver Assembly 19 10 x 10 Flat Top Louvered Pergola Repeat for other two rows. Place the Post Caps onto the posts. 10 www.newenglandarbors.com 11 11 10 …

3, Introduction & Overview 3 10 x 10 Flat Top Louvered Pergola Getting Started &IRSTOFf,ALLOWUSTOSAYTHANKYOUfORTHEINVESTMENTYOUHAVEMADEINONE OFOURFINEpERGOLA KITS THIS KITISDESIGNEDTO BEASSEMBLED AND I…

21, 21 10 x 10 Flat Top Louvered Pergola To adjust the positions of the louvers, slide the Turn Bar in between two louver boards and turn in a circular motion to the desired position. Excessive force should not be required. For best leverage, push with the arm of the Turn Bar as opposed to ‘prying�…