Liebert MPX Operation & User’s Manual

37, 4 OPERATING AND CONFIGURING RACK PDUCARDS The Liebert® RPC2™ communications module is an optional rack PDUcard that allows you to monitor and configure components connected to the MPX™unit through a web-based interface. The card provides enhanced monitoring and control, enabling you…

27, Liebert MPX The locking clamp reduces the chance of accidental disconnection of the MPX IPC because the clamp must be removed before the connector can be disengaged. The locking clamp is optional and not required for typical Liebert® MPX™ system applications. To attach the MPX IPC locking clamp: 1. V…

24, To attach an MPX PEM to an MPX PRC: 1. Ensure the module’s circuit breaker is in the off/open position and the screw latches at each end of the MPX PEM are positioned to fit into the MPX PRC slot. Figure 2.4 MPX™ PEM Bottom View 2. Position the MPX PEM so the power blades align wi…

32, Figure 2.12 RPC™BDM ITEM DESCRIPTION 1 Scan switch 2 RJ45 communication and power input port Table 2.4 RPC BDM Components To install an RPC BDM on a rack frame: 1. Determine the mounting location on the frame member where the RPC BDM will be installed. 2. Insert a spring nut into a …

17, Figure 1.7 RPC2™ Communications Module ITEM PORT DESCRIPTION 1 Serial Used for the RS232 serial console using the CLI 2 USB Micro-AB Used for the USB memory stick 3 Sensor Used to connect optional Liebert® SN sensor accessories 4 Display Used to connect the RPC BDM 5 Link Used for: • Lo…

40, 4.2 Operating Rack PDUCards Depending on the model of the communications module, see the Liebert® RPC™ Web Card User Manual (SL-20825) or the RPC2™ Communications Module Installer/User Guide for instructions to operate a Liebert MPX™ rack PDUequipped with a communications module. Y…