MICRO-EPSILON optoNCDT ILR 1191 Instruction Manual

59, Page 59 Warranty optoNCDT ILR 1191 14. Warranty All components of the device have been checked and tested for perfect function in the factory. In the unlikely event that errors should occur despite our thorough quality control, this should be reported immediately to MICRO-EPSILON. …

8, Page 8 Safety optoNCDT ILR 1191 Avoid shock and vibration to the sensor. > Damage to or destruction of the sensor Protect the cables against damage. > Failure of the measuring device Do not turn the module on if there is fogging or soiling on its optical parts. > Failure of t…

2, MICRO-EPSILON MESSTECHNIK GmbH & Co. KG Königbacher Strasse 15 94496 Ortenburg / Germany Tel. +49 (0) 8542 / 168-0 Fax +49 (0) 8542 / 168-90 e-mail [email protected] www.micro-epsilon.com Certified acc. to DIN EN ISO 9001: 2008 Laser-based distance sensor …

57, Page 57 Hyperterminal optoNCDT ILR 1191 Fig. 22 User interface in terminal operation i A currently entered command will only be displayed if “Local echo“ is enabled. This function can be ac- cessed via file menu File > Properties > “Settings“ tag > ASCII Setup. Save f…

11, Page 11 Laser Class optoNCDT ILR 1191 turer of laser devices. Although the laser output is low looking directly into the laser beam must be avoided. Due to the visible light beam eye protection is ensured by the natural blink reflex. i Do not look directly into the laser beam! Clos…

43, MICRO-EPSILON optoNCDT ILR 1191 Page 43 Control Commands optoNCDT ILR 1191 10.3.3 PR – Reset to Factory Settings Format: PR [Enter] Resets all parameters to their factory settings. Except is the baud rate. Parameter for firmware version 1.1.16: measure frequency[MF] 2000(max2000)hz trigger delay/level[TD] 0.00msec 0 aver…