MICRO-EPSILON ILD2200-2 Instruction Manual

49, Page 49 Serial Interface RS422 optoNCDT 22xx Example: Sensor operates in the average mode “Median“. The command AVGn is not possible in this opera- tion mode and leads to the following answer. 31 24 23 16 15 8 7 0 hex Contents “I“ “L“ “D“ “1“ 0x494C4431 Identifier…

24, Page 24 Installation optoNCDT 22xx ILD22xxLL5.2.3 80 (3.15) 3x Mounting holes ø4.5 mm (0.18 dia.) 89 (3.50) 97 (3.82) 67 (2.64) 37.5 (1.48) 4 75 (2.95) 13.4 (0.53) A B Start of measuring range End of measuring range MR SMR ø8 (0.31 dia.) 15 (0.59) ø4 (0.16 dia.)…

48, Page 48 Serial Interface RS422 optoNCDT 22xx Command Reply, Communication without Error7.2.1 No start word is transmitted, if the sensor replies to a command. The 1st word then is the sensor identifier. The second word is the command with set MSB (Bit 31 = 1, corresponding an O…

58, MICRO-EPSILON ILD2200-2 Page 58 Instructions for Operating optoNCDT 22xx Error Influences8.2 Color differences Because of intensity compensation, color difference of targets affect the measuring result only slightly. How- ever, such color differences are often combined with different penetration depths of t…

35, Page 35 Measuring Setup and Commissioning optoNCDT 22xx Example 3: Averaging with median Measurement object: Rotating metal part with low unbalance and slight scratching Measured value No average Measured value Median MW3 Measured value Median MW9 Non-averaged output signal: In the adjacent …

14, Page 14 Functional Principle, Technical Data optoNCDT 22xx Model ILD22xx 2 10 20 40 50 100 200 500 ILD 2210-10 ILD 2210-20 Supply voltage 24 VAC (±15 %), max. 500 mA Sensor cable Standard: 2 m (6 ft) - integral Option: 5 m / 10 m (16 / 32 ft) 1 Controller Functions: Zero / Averaging Di…