Lanner LVC-5550S Operation & User’s Manual

19, 19 Board Layout Chapter 3 Embedded and Industrial Computing Select MCU Detect Function for power ignition behavior (SW1): The function of the above jumpers are further explained here. Power Good Detection1. : A power-good signal from the main board will be sent to the ig…

30, 30 Digital Input/Output Control Appendix B Embedded and Industrial Computing exit_SIO_config(); return; } void dio_set_output(unsigned char out_value) { enter_SIO_config(); write_SIO_reg(0x6, 0xf1, ((read_SIO_reg(0x6, 0xf1)& 0xF0)|out_value)); exit_SIO_config(); …

17, 17 Board Layout Chapter 3 Embedded and Industrial Computing DVI-D Connector (DVI1): The video display is powered by Intel®GMA 3650 graphics engine. VGA in DB-15 connector (VGA1): It is used for connecting a VGA monitor. Power-Out Connector (CN6): 12V DC Power-out connect…

35, Lanner LVC-5550S 35 Accessing the GPS Data Appendix C Embedded and Industrial Computing The hyper terminal should display GPS data: …

21, 21 Hardware Setup Chapter 5 Embedded and Industrial Computing Chapter 5: Hardware Setup Preparing the Hardware Installation To access some components and perform certain service procedures, you must perform the following procedures first. WARNING: To reduce the risk of personal inju…

26, 26 Digital Input/Output Control Appendix B Embedded and Industrial Computing Choose to select the hardware Manually8. Choose Show all device and click Next.9. Click HaveDisk to locate the L_IO.inf file10. Click HaveDisk to locate the L_IO.inf file11. Select the L_IO.inf12. Select OK …