Hameg HM8118 Operation & User’s Manual

8, 44 Description of the Operating Elements Fig. 2.2: Back panel of HM8118 47 48 45 4446 49 31 N-Θ / . – Selection of the measurement function ‘Turns ratio‘ N and ‘Phase angle‘ Θ resp. parameter input of the character “. “ 32 C-R / 4 – Selection of the measurement function ‘Ca…

17, 53 Instrument Functions The LCR bridge HM8118 generates a sinusoidal measure- ment AC voltage between 50 mV eff and 1.5 V eff with a re- solution of 10 mV eff . You can set the measurement AC vol- tage either in the SETUP menu via LEV or via LEVEL 9 key by means of the knob …

2, Hameg HM8118 38 General information concerning the CE marking General information concerning the CE marking General remarks regarding the CE marking Hameg measuring instruments comply with the EMI norms. Our tests for conformity are based upon the rele- vant norms. Whenever different maximum limits are…

33, 69 Command Reference measurement values to be used for the calculation of the average. The AVGM? query queries the status of the calcu- lation of the average. NAVG(?) {i} If you use the AVGM command to set the calculation of the average to i=1, you can use the NAVG command to set th…

20, 56 Instrument Functions In the SETUP menu, use the arrow keys 7 to se- lect the GUARD function, press the knob 6 (editing mode) and select the desired setting via knob. Press the knob again to conrm the selection. The HM8118 GUARD function is not comparable to the 4TP function (= Four T…

11, 47 First-Time Operation shown in the right panel and the essential parameters in the left panel of the display. The four BNC sockets located on the front panel can be connected to the component to be measured with the appropriate measuring accessories. Additionally, it is also possib…