Gemtek Systems CPE7000 Quick Installation Manual

5, CPE7000 Outdoor Dual Mode - Quick Installation Guide Easy Setup Follow the steps below to configure your device through the web interface: Step 1: Click the web browser (Internet Explorer) and enter default IP address of the ODU CPE: http://192.168.254.251 Step 2: Enter ODU administrator…

2, Gemtek Systems CPE7000 CPE7000 Outdoor Dual Mode - Quick Installation Guide Mounting the ODU     Mount the ODU unit on a 1"-4" pole using the supplied kit (Figure 1), or the optional Tilt accessory. Using the Clamp 1 Tread the M10*100mm bolt through a spring…

6, CPE7000 Outdoor Dual Mode - Quick Installation Guide Checking for Proper Operation  Verify data connectivity by sending a ping command to the BTS or by connecting to the Internet.  Check the LED functionality according to the following table: LED Name Location Color LED …

4, CPE7000 Outdoor Dual Mode - Quick Installation Guide Preparing and Connecting the Cable Use only Category 5E 4x2x24# FTP outdoor cables from an approved manufacturer. The cable provides pin-to-pin connection on both ends. 1. Prepare the cable: Use a crimp tool for RJ-45 conn…

3, CPE7000 Outdoor Dual Mode - Quick Installation Guide Connecting the Cables <Figures 2> demonstrates how ODU Device connected. Be sure RJ-45 and telephone line are well connected to ODU Device. • Using a phone line to connect the telephone with RJ-11 port. • Available …