BMS Truck-Coder II Installation And Operation Manual

38, 30 PIN OUTS IDU 85 – 265 VAC 2 AMP ASI WARNING 48 VDC PRESENT ON THIS CONNECTOR 70 MHz/ 48 VDC/ TM OUT OFF ON 48 VDC AUXILIARY INPUTS SUMMARY ALARM OUT IN OUT IN AUDIO2 IN AUDIO1 IN SDI IN W/ AUDIO VIDEO IN RS-232 DCE TELEMETRY RS-232 CONTROL RS-232 AUX DATA 10/100 ETHERNET 70 M…

11, BMS Truck-Coder II 3 The FM modulator is designed to accept analog audio and video inputs. Support for 2 audio channels is provided via frequency programmable sub carriers that ride above the video signal The frequency deviation is user configurable to support operation in either a 17 MHz or 12 MHz channel allow…

30, 22 OPERATION NOTE: Follow all procedures precisely to ensure initialization & operation. Initialization 1. Power the TCII on by switching the System Power to the ON position. The green indicator light to the right of the power switch will turn on immediately. 2. The TCII will im…

7, v WARNING! RF RADIATION EXPOSURE HAZARD This warning is provided by Broadcast Microwave Services (BMS) Inc. for safety purpose. The following information help to reduce the risk of RF exposure hazard. FCC Limit of RF Exposure According to Federal Communication Commission (FCC…

21, 13 19.0 in 48.3 cm 3.5 in (8.9 cm) 14.9 17.5 in 44.1 cm Do Not Block Fan Inlets or Outlets Do Not Block Fan Inlets or Outlets Figure 4 IDU Footprint …

27, 19 Figure 9 ODU Mounting Footprint 1. Secure the ODU to the custom antenna mast mount with 16-#10 screws (included in installation kit BMS P/N 7614191020.) Note: The Orientation of the ODU is critical to the performance of the TCII system. The ODU must be mounted on the Antenna mast so …