H3C S5500-EI series Configuration Manual

439, 420 # Enable IPv6 multicast routing, MLD and IPv6 PIM-DM on Switch B and Switch C in the same way. (Details not shown.) # Enable IPv6 multicast routing on Switch D, and enable IPv6 PIM-DM on each interface. <SwitchD> system-view [SwitchD] multicast ipv6 routing-enable [SwitchD] inter…

215, H3C S5500-EI series 196 # Enable IP multicast routing and administrative scoping on Switch A, enable IGMP on VLAN-interface 100, and enable PIM-SM on each interface. <SwitchA> system-view [SwitchA] multicast routing-enable [SwitchA] pim [SwitchA-pim] c-bsr admin-scope [SwitchA-pim] quit [SwitchA] inte…

219, 200 PIM-SM BSR RP information: Group/MaskLen: 224.0.0.0/4 RP: 10.110.9.1 Priority: 192 HoldTime: 150 Uptime: 00:03:42 Expires: 00:01:48 Group/MaskLen: 239.0.0.0/8 RP: 10.110.4.2 (local) Priority: 192 HoldTime: 150 Uptime: 00:06:54…

90, 71 Figure 24 Network diagram Configuration procedure 1. Configure an IP address and subnet mask for each interface as per Figure 24. (Details not shown.) 2. On Router A, enable IP multicast routing, enable PIM-DM on each interface and enable IGMP on the host-side interface …

412, 393 Configuring a legal range of BSR addresses enables filtering of bootstrap messages based on the address range, thereby preventing a maliciously configured host from masquerading as a BSR. You must make the same configuration on all routers in the IPv6 PIM-SM domain. Typical BSR s…

125, 106 • A host that is running IGMPv1 or IGMPv2, however, cannot specify multicast source addresses in its report. In this case, you must configure the IGMP SSM mapping feature to translate the (*, G) information in the IGMPv1 or IGMPv2 report into (G, INCLUDE, (S1, S2...)) inform…