Cineversum THEATRE Concept Manual, Assembly And Calibration

11, page 11 G H Press the RCU button 2 or apply 12 Volts to the RF-emitter to move the Anamorphic lens in front of the projector beam. Scaler settings: Menu -> Input AR -> Active AR -> 2.35 The picture format changes to Cinemascope® (2,35:1 format) and fulfi lls the scr…

1, www.cineversum.com Part. No.: R599752 THEATRE Concept ASSEMBLY AND CALIBRATION Date: 24092007 Rev: 04 …

3, page 3 Table of content Did you know that ? .................................................................................................... 2 Assembly Instructions: ............................................................................................... 4 Technical data: .........…

8, page 8 A B Attach THEATRE Anamorphic Lens to the slider ring. Tighten the four fixing screws to fix the lens. Mounting the Anamorphic Lens (fig. A-B) …

18, Cineversum THEATRE Concept ZOOM page 18 2.40:1 movie into a 2.35:1 Cinemascope® screen: When projecting a movie with a different format from your screen, the picture obtained won’t fi ll the total height of the screen. In the example below, the movie aspect ratio is 2.40:1 and the sc…

14, page 14 L Setting vertical position and tilt (fi g. L-M) A pincushion distorsion appears when the Theatre lens is not aligned with the projector beam on the vertical axis. Use the Xhatch fi ne Test Pattern to set the lens tilt. Locate the screws indicated below and release them to set th…