Eurotherm P304c Operation & User’s Manual

36, P304c Controller User Manual 5.3.7 Retransmission The measured pressure can be retransmitted as an analogue value on OUT2, terminals 56 and 57. Code Description Range P55 Configures the Type of Retransmission Available only if the retransmission circuit is fitted. OFF …

13, P304c Controller User Manual 1.5.8 Digital Inputs • Four optional digital inputs are provided for control purposes plus one for reset purposes. • The interface circuit is opto-isolated with respect to the CPU, analogue inputs and outputs, but not isolated with respect…

23, P304c Controller User Manual At.iP AUTOMATIC SELECTION OF THE INTEGRAL PRE LOAD VALUE Setting this parameter to Auto causes the controller to calculate the integral pre load value using the set point and process gain values. The process gain value is estimated during the au…

39, P304c Controller User Manual 5.3.12 Manual/Auto Start-Up Code Description Range P86 Configures the Controller status at power on. The controller can be made to start up in Manual mode (power output demanded manually) or Automatic – power output controlled in closed loop.…

63, P304c Controller User Manual Strain gauge input from 340 to 5000 ohm, 1-4 mV/V. Excitation 10V +/- 7%. 5 wire connection. Interfacing 1mV/V sensors could worsen the noise performance Input signal -25/125% of full scale (approximately - 10/50mV Shunt calibration with…

33, Eurotherm P304c P304c Controller User Manual 5.3.2 Pressure Input Selection Code Description Range P1 Configures the Type of Pressure Input. Note: Remember to properly wire the unit’s terminal block Str Strain gauge (default) 0-20 0-20 mA 4-20 4-20 mA 0-…