Chelsio Communications Chelsio T5 Installation And User Manual

28, Chapter III. iSCSI PDU Offload Initiator Chelsio T5/T4 Unified Wire For XenServer Page 28 E.g.:- force_start() { echo -n $"Starting $prog: " modprobe -q iscsi_tcpmodprobe -q ib_iser modprobe -q cxgb4i modprobe -q cxgb3i modprobe -q bnx2i modprob…

13, Chelsio Communications Chelsio T5 Chapter I. Chelsio Unified Wire Chelsio T5/T4 Unified Wire For XenServer Page 13 5. Finally, unmount the ISO image: [root@host]# cd [root@host]# umount /tmp/iso 3.3. Firmware Update The T5 and T4 firmwares are installed on the system, typically in /lib/firmware/cxgb4, and …

9, Chapter I. Chelsio Unified Wire Chelsio T5/T4 Unified Wire For XenServer Page 9 b. And for T4 adapters : [root@host]# lspci | grep –i Chelsio 03:00.0 Ethernet controller: Chelsio Communications Inc T420-CR Unified Wire Ethernet Controller 03:00.1 Ethernet controller: Chelsio …

11, Chapter I. Chelsio Unified Wire Chelsio T5/T4 Unified Wire For XenServer Page 11 3. Software/Driver Installation Chelsio Unified Wire must be installed by the root user. Any attempt to install the software as a regular user will fail. There are two methods of installation: Duri…

16, Chapter II. Network (NIC) Chelsio T5/T4 Unified Wire For XenServer Page 16 II. Network (NIC) …

18, Chapter II. Network (NIC) Chelsio T5/T4 Unified Wire For XenServer Page 18 2. Software/Driver Loading The driver must be loaded by the root user. Any attempt to load the driver as a regular user will fail. To load the driver, execute the following: [root@host]# modprobe cxgb4 …