Check-line RH6 Manual 

10, Check-line RH6  Electromatic Equipment Co., Inc. -10- 5. Now put the third gasket ring into the bottom part. 6. Fit the metal ring on the third gasket. 7. Take the upper part with the RH6 and attach these carefully at the bottom part of the calibration device. 8. Pick up the …

8,  Electromatic Equipment Co., Inc. -8- 9.0 PRINT SAVED DATA To print your saved data, connect the device to the printer using the printer cable that was delivered with your device. Carefully loose the protection cap on the RH6. At first plug in the side of th…

2,  Electromatic Equipment Co., Inc. -2- 1.0 POSITIONING THE INSTRUMENT Insert the sword-sensor into the stack for only approx. 10 cm, and push it a few more centimetres into the stack every 10 seconds. Let your RH6 adequately adjust to the material (at least 5 minutes…

1,  Electromatic Equipment Co., Inc. -20- NOTES  Electromatic Equipment Co., Inc. -1- TABLE OF CONTENTS 1.0 Positioning the instrument ……………………………………………. 2 2.0 Calibration curves ………………………………………………�…

7,  Electromatic Equipment Co., Inc. -14- 16.0 EXEMPTION FROM LIABILITY For miss-readings and wrong measurements and of this resulting damage we refuse any liability. This is a device for quick determination of moisture. The moisture depends on multiple conditio…

6,  Electromatic Equipment Co., Inc. -6- 7.0 OPERATING THE INSTRUMENT Switching on: Press for 3 seconds. Changing the calibration curve: or . Setting the time: 2 times - Options – Date / Time Set date and time using the button , according to the …