Ethernet Direct HUSKY HUE-500SN Operation & User’s Manual

6, Hardware Installations 2-2 2-2 LED Indicators There are diagnostic LEDs located on the front panel of HUE-500SN & HUE-500SEN. They provide primary information on switch status as described in the table below. LED Name LED Color Status Definition ON Lit if pow…

10, A-1 A A p p p p e e n n d d i i x x A A Specifications HUE-500SN & HUE-500SEN Product Specifications are as follows: Hardware Interface RJ-45 Ports 5 x 10/100Base-T(X) auto-negotiation speed, Full/Half duplex mode, auto MDI/MDI-X Per Unit PWR (Green) LEDs Per Por…

3, Table of Contents Chapter 1................................................................................................................................................................1-1 Introduction..........................................................................…

12, A A p p p p e e n n d d i i x x B B Troubleshooting Select the proper UTP cables to construct your network. Please check that you are using the right cables. Use unshielded twisted-pair (UTP) or shield twisted-pair (STP) cables for RJ-45 connections: 100Ω Category 3, 4 or 5…

9, Ethernet Direct HUSKY HUE-500SN Hardware Installations 2-5 Before connecting any network device, make sure network devices support auto MDI/MDI-X. If not support, use the cross over Category 5 /5ecables. After all wiring and connection are done and the LED lights on the switch’s front panel show…

1, HUE-500SN HUE-500SEN Industrial 5 x 10/100Base-T(X) Slim Unmanaged Ethernet Switch User’s Manual V1.0 03-28-2017 …