Estun PRONET-10AMA Operation & User’s Manual

131, ProNet series AC servo system User ’ s manual V.1.08 - 130 - Para Para Para Para . . . . No. No. No. No. Name Name Name Name Unit Unit Unit Unit Setting Setting Setting Setting Range Range Range Range Factory Factory Factory Factory Setting Setting Setting Setting Setting …

96, Estun PRONET-10AMA - 95 - Chapter 5 Panel Operator 5.1 Basic Operation 5.1.1 Functions on Panel Operator Panel operator is a built-in operator that consists of display part and keys located on the front panel of the servodrive. Parameter setting, status display and execution of utility function are enabled us…

33, ProNet series AC servo system User ’ s manual V.1.08 - 32 - 3.5.2 Three-phase 200V (ProNet-08A ～ 50A) Noise Fi lter L1 L2 L3 Thr ee-phase 200~230V ( 50/60Hz ) + 10% - 15% Power OFF Power ON 1 KM 1SUP 1 KM 1 Ry L 1 L2 L3 1 2 W V U M PG Servomotor Encoder A( 1) B( 2) …

132, Appendix A Parameter - 131 - Para Para Para Para . . . . No. No. No. No. Name Name Name Name Unit Unit Unit Unit Setting Setting Setting Setting Range Range Range Range Factory Factory Factory Factory Setting Setting Setting Setting Setting Setting Setting Setting Invalidation Inval…

49, ProNet series AC servo system User ’ s manual V.1.08 - 48 - 4.2 Control Mode Selection The control modes supported by the ProNet series servodrives are described below. 4. 3 Setting Common Basic Functions 4.3.1 Setting the Servo ON Signal This sets the servo ON signal (/S-ON) tha…

140, Appendix A Parameter - 139 - Para Para Para Para . . . . No. No. No. No. Description Description Description Description Setting Setting Setting Setting Validation Validation Validation Validation Control Control Control Control Mode Mode Mode Mode Function Function Function Function and and a…