Dynalco SC-2124 Installation And Operation Manual

40, 40 Channel 14 Input Settings Parameter Function Description Valid Inputs 110.14= Channel name for CH14 Default=” “ (blank=CH14) 11 characters (including spaces) 111.14= Units of measure for CH14 0= deg F (default) 1= deg C 2= PSI 3= PSA 4= KPA 5= FTP 6= RPM 7= “ �…

64, Dynalco SC-2124 63 63001.58=0 ; <USER TRIP #10> ; USER TRIP HYS *************************** ; TRIP hysteresis; difference between fault ; threshold of TRIPPED channel and clear- ; fault threshold (in channel units). 63002.49=0 ; <USER TRIP #01> 63002.50=0 ; &…

11, 11 Connector E (DB-25F) This Connector provides the Analog Inputs for Channels 13 – 24. Pinout: Pin# Pin Name Pin# Pin Name 1 Channel 13 (+) 14 Channel 13 (-) 2 Channel 14 (+) 15 Channel 14 (-) 3 Channel 15(+) 16 Channel 15 (-) 4 Channel …

7, 7 2.0 Installation Installation requires a cutout as shown in section 2.1 along with four mounting holes. Once the unit is mounted, a nearby (less than 6 feet away) location is needed for performing the wiring to separate terminals. One method is to purchase the optional DB-to-Sc…

17, 17 4.1 RESET After power-up, the SC-2124 starts up in a RESET condition that assumes that all channels are in a non-fault state, initializes the ALARM and SHUTDOWN TRIP conditions to a non- fault state, and forces all relays and discrete outputs to their non-fault states. Aft…

15, 15 3.1.2 Configuration File The easiest method for the user to configure the SC-2124 is by editing and downloading a configuration file to the SCANNER. The configuration file is a template file that contains all configurable parameters and an explanation for all parameter…