Leader LT 4448 Instruction Manual

39, 4. HOW TO USE 32 ● P2 (15- pin D-sub) Connect to the LTC IN/OUT connector on the rear panel of the primary signal source LT 4610. Pin No. Pin Name I/O Pin No. Pin Name I/O Pin No. Pin Name I/O 1 OPEN - 6 OPEN - 11 OPEN - 2 LTC1+_P I 7 OPEN - …

52, 6. ETHERNET CONTROL 45 6.1.2 Uninstallation To uninstall the software, select “lt4448”in Programs and Features of Control Panel, and click Uninstall. Figure 6-5 Uninstallation …

21, Leader LT 4448 3. PANEL DESCRIPTION 14 3.3 Top Panel Figure 3-3 Top panel Table 3-3 Top panel description No. Name Description Reference 1 DIP switch cover Remove the four screws to access the DIP switches. You can use the DIP switches to configure the LT 4448. An explanation of the DIP …

18, 2. SPECIFICATIONS 11 2.3.10 General Specifications Environmental Conditions Operating Temperature 0 to 40 °C Operating Humidity Range 90 %RH or less (no condensation) Optimal Temperature 5 to 35 °C Optimal Humidity 85 %RH or less (no condensation) Operating Environment Indoor…

40, 4. HOW TO USE 33 4.8 LT 4448 Configuration The LT 4448 has a last-memory feature. When the power is turned on, the LT 4448 is set to the conditions that it was in when the power was turned off the last time. 4.8.1 Setting the Key Lock The LT 4448 locks its keys after 1 minute of inactivit…

47, 5. REMOTE CONTROL 40 Table 5-1 Remote connector functions Pin No. Name I/O Description 1 AUTO SWITCHING I When the front-panel AUTO SWITCHING is set to SWITCH FAULT, applying a low-level signal sets AUTO SWITCHING to DISABLED, and applying a high-level signal (or openin…