AOR AR-ONE Operating Manual

41, 40 BPS Communication data speed setting RMT-ID RS-232C identification address setting DELAY Scan/Search delay setting FREE Scan/Search free setting SPEAKER Speaker/headphones setting HPF/LPF Audio Filter setting DE-Emphasis De-emphasis setting PRIO-CH …

8, AOR AR-ONE 7 frequency range, either from the currently displayed frequency traveling upwards (or downwards) in a specified tuning increment (step) or by sweeping over-and-over between two specified frequency limits. This process is known as SEARCHING, as the title implies, it can…

45, 44 level for best reception. Push the ENT key to accept the data and return to a standard display. Alternatively, push the ESC key to abort entry, or, push the down arrow key to move to the next item on the configuration menu (RF-GAIN). 6-7 Configure RF-…

65, 64 MEMORY DATA LIST – Read only MAn (n: 0 – 9) Bank number, memory data between CH00 to CH10. MA MA Memory data for bank number higher than 10 [Example]: MXmnn MPn GAn RFnnnnnnnnnn AUn MDn BWn ATn AMn TMxxxxxxxx SELECT MEMORY ON/OFF GAn (n: 0 or 1) Memory select On/Of…

54, 53 or specified response should come back from the receiver after confirming the correct command. If no response has been gained after a short while, the receiver has failed to receive the command properly. Send a [CR] then re-send the command. Should problem persist, check yo…

44, 43 is set OFF. The default setting for Manual AGC is 255, maximum gain control value. The value can be adjusted according to the receiving condition. To access the configuration menu, push the FUNC key and then push the 7 key. Push the down arrow key to move the cursor to the “MANU AGC�…