ATSI PCMT-8000 Operation & User’s Manual

71, 10. Service and Calibration 10. Service and Calibration The PCMT-8000 has no user serviceable parts. Under no circumstances should the user attempt to open the enclosure. If the tester appears to be malfunctioning, contact ATSI to make arrangements for repair. See the Limited Warra…

44, 7. Test Descriptions 4. Check Stop Time contacts. 5. Remove conflict 6. Reset monitor. Monitor Response to PASS : Stop Time Open contacts closed on conflict. Stop Time Open contacts open with no conflict. 24VDC Loss Ignore Timing Test Description : Verify that the monitor ignores a loss of 24VDC …

27, 7. Test Descriptions 7. Repeat 3 through 6. Monitor Response to PASS : Loss of DC power for more than 175ms must cause the monitor to go into the fault state. DC1 Monitor Auto Reset Test Description : Verify that the monitor goes into the fault state when DC1 is removed, and t…

38, 7. Test Descriptions 1. Monitor is powered up in the quiescent state. 2. Watchdog signal is removed. Monitor Response to PASS : Watchdog Fail Indicator must be on. The user must verify by clicking yes in the pop-up window. GRN/GRN, GRN/YEL, GRN/WLK, YEL/GRN, YEL/YEL, YEL/WLK, WLK/GRN, WLK/…

13, ATSI PCMT-8000 6. Using the Test Manager Software 6.4. PCMT Info Click on the PCMT Info menu item to open the PCMT Info window. If the PCMT is connected to the computer with the USB cable, clicking on the Get PCMT Info button will connect to the PCMT and report the Serial Number, Firmware Version, an…