astra telematics AT210 Installation Manual

1, AT210 Installation Guide 1. Check that the back-up battery is fitted and plugged-in: a. Each AT210 is supplied with a 450mAh back-up battery, which should be fixed to the PCB and connected as shown below: b. Do not attempt to remove the battery from the …

2, 3. Fit the DB9 Cable a. Connect the sealed DB9 cable and tighten the jack-screws finger tight, until the seal is compressed against the enclosure end panel 4. Hook up the electrical connections a. Connect the RED and BLACK wires to a PERMANENT +12V/+24V vehicle power source via a 3A …

3, astra telematics AT210 7. Check status LEDs a. Place the AT210 (or AE004 GNSS antenna) somewhere with reasonable view of the sky in correct orientation for a minute or two and then check the status LEDs as below: GNSS status GSM status External power …

4, 9. Mount the AT210 under the vehicle dashboard a. Choose a position towards the top of the dashboard and as far forwards as possible to give the optimum view of the sky through the vehicle windscreen b. There must be no conductive objects between the AT210 and the windscreen (i.e. …

5, 10. Check Status and Commission Device a. Before replacing panels and leaving the vehicle, we STRONGLY recommend that you confirm normal operation and good communication, using either method below: i. Calling the service provider to check that the device is online, conf…