Baldor BC140 Installation And Operation Manual

21, 21 2.8 Voltage Select Switch The Voltage Select Switch must be set as described in Section 6. For 208/230 Volt AC line input, set the Voltage Select Switch to the “230” position (factory setting). For 115 Volt AC line input, set the Voltage Select Switch t…

24, 24 4. ELECTRICAL CONNECTIONS See Table 4-1 for Barrier Terminal Block wire size and recommended tightening torque specications. WARNING! READ SAFETY NOTICES BEFORE ATTEMPTING TO USE THIS CONTROL. DISCONNECT THE MAIN POWER BEFORE MAKING CONNECTIONS TO THE…

18, 18 2. QUICK START IMPORTANT – You must read these simplified operating instructions before you proceed. These instructions are to be used as a reference only and are not intended t…

28, 28 Table 4-3 Plug-In Horsepower Resistor ® and Armature Fuse Kit Information Motor Horsepower Approximate Motor Current (Amps DC) Plug-In Horsepower Resistor ® and Armature Fuse Kit Armature Voltage 90 – 130 Volts DC Armature Voltage 180 Volts DC Plug-In Horsepower Resistor ® Value…

47, 47 12. OPTIONAL FORWARD-BRAKE-REVERSE SWITCH (CATALOG NO. BC144)* WARNING! READ SAFETY NOTICES BEFORE USING THIS CONTROL. DISCONNECT THE MAIN POWER BEFORE MAKING CONNECTIONS TO THE CONTROL. The optional Forward-Br…

34, Baldor BC140 34 7.2 Deceleration Trimpot (DECEL) The DECEL Trimpot controls the amount of rampdown time when the Main Speed Potentiometer is adjusted to a lower speed. The DECEL Trimpot is factory set to 2 seconds, which is the amount of time it will take for the motor to decel…