Arbiter Systems 1088A Operation Manual

87, 8.2 Event Inputs 67 Where: “nnn” = event number (001 to 200) “ddd” = day of year of the event (1 to 366) “hh” = hour of the event (00 to 23) “mm” = minute of the event (00 to 59) “ss.sssssss” = second and fractional seconds of the event (e.g. 59.9999999) Press the UP or D…

273, Arbiter Systems 1088A Appendix E Statement of Compliance E.1 Introduction The following page is a statement of compliance that includes Model 1088B. …

2, ii Description This manual is issued for reference only, at the convenience of Arbiter Systems. Reasonable effort was made to verify that all contents were accurate as of the time of publication. Check with Arbiter Systems at the address below for any revisions made since the original date of …

29, 2.3 Rear Panel Identification and Connectors 9 2.3.1 Power Inlet To cover all of the possible inlet power conditions, the Model 1088B has three optional power supplies. Please examine the paperwork you received, to make sure you have correctly identified the inlet connection. Supply types are l…

226, 206 Options List C.22.3 Web Interface Instructions in this section cover the setup and maintenance of the Option 34 using the Web Interface. Configure the Option 34 insecurely through the Web Interface using HTTP, or securely using HTTPS. Both methods are discussed in this section. Instructions on…

71, 6.9 Setting the Event/Deviation Modes (A or B) 51 6.9.1 Arming the Event Input When using J3 or J4, note that the event function continually arms itself for the next event until the buffer is full. When using the RS-232C port as the input, you must arm the event function for each even…