Anritsu PIM Master MW82119A Maintenance Manual

47, 5-4 Front Panel Assemblies Chapter 5 — Assembly Replacement 5-12 PN: 10580-00286 Rev. D MW82119A MM 9. Peal up the rubber keypad membrane (Figure 5-17). 10. Carefully pry up the speaker with a stub nosed pick. Note that the front side of the speaker has a gasket (Figure 5-18). Figure 5-17.…

55, 5-5 Chassis Assemblies Chapter 5 — Assembly Replacement 5-20 PN: 10580-00286 Rev. D MW82119A MM Figure 5-28. GPS Module with MMCX Cable attached Figure 5-29. GPS SMA Connection on connector panel (inside and outside view) …

39, 5-3 Front Panel Removal Chapter 5 — Assembly Replacement 5-4 PN: 10580-00286 Rev. D MW82119A MM 5. Remove the Top Bumper and Handle Hand Strap (Figure 5-4). The top bumper part number is 3-72496. Figure 5-4. Remove the Top Bumper …

25, 2-4 Residual PIM Measurement Chapter 2 — PIM Analyzer Verification 2-8 PN: 10580-00286 Rev. D MW82119A MM 2-4 Residual PIM Measurement The following test is used to verify the residual PIM of the PIM Master. The procedure measures the internal residual PIM of the PIM Master. Equ…

15, 1-5 Recommended Test Equipment Chapter 1 — General Information 1-4 PN: 10580-00286 Rev. D MW82119A MM 1-5 Recommended Test Equipment Table 1-3 lists the test equipment that is required for verifying and testing the PIM Master. 1-6 Replaceable Parts and Assemblies Table 1-4. Li…

34, Anritsu PIM Master MW82119A Chapter 4 — Battery Information 4-2 Battery Pack Removal and Replacement MW82119A MM PN: 10580-00286 Rev. D 4-3 3. Remove the battery access door by sliding it out of the slot in the case, as shown Figure 4-3. Figure 4-3. Removing the Battery Access Door …