AeroWorks EXTRA 260 ARF-QB Assembly Manual

84, 84 6. Insert two cowl mounting bolts with rubber backed washers through the template from the bottom up. 7. Mount the template to the bottom of the cowl mounting tabs with two cowl mounting bolts and rubber backed washers as shown. 8. Lift the template so that it contacts the b…

83, 83 2. Apply clear tape to the edge of the folder template as shown. 4. Mark the center of the blind nut in the lower cowl mounting tabs from the top down with a T-pin. 3. Tape the template to the bottom of the fuse with the back edge of the template flush against the aft edge of…

31, 31 6. Install rudder servos with servo screws. Rudder Servo Arm Coupler 1. Gather the rudder servo arm coupler hardware as shown below. There are (4) 4-40 ball links with hardware, (2) 4-40 all thread rods, and (2) car- bon sleeves Note: Rudder coupler hardware i…

18, 18 4. Install the servo arms facing toward the wing tip as shown. 5. Align the control horns over the factory drilled holes. 6. Use thick CA on each screw prior to installing to lock screws in place Note: CA glues have a fast drying time. Remember to work qui…

80, 80 8. A typical ignition installation shown below. Secure the regulator to the fuse floor using manufactures suggestion instructions. Radio Installation 1. Gather the receivers, batteries, and regulators as shown below. 2. Mount the receivers, batteries, and regulato…

64, AeroWorks EXTRA 260 ARF-QB 64 14. Insert the pieces of silicon tubing into the plywood cutouts in the pre-cut canister mounting formers. 15. Dry fit the aft canister mounting former to fit behind the first former behind the air exit holes. Apply thick CA or epoxy and glue in place. 16. Ensure …