AERMEC MODUCONTROL Usage Manual

17, AERMEC MODUCONTROL 51 GB 6343841_00 / Ver - 4.20 Setting heating set 2 Index - String MIN value MAX value Parameter function j j 25°C (*) This parameter indicates the minimum value of the heating setting, corresponding with the maximum outside air temperature (index (C) user menu). This parame…

34, 68 GB 6343841_00 / Ver - 4.20 READ LIST REGISTER: ADDRESS DESCRIPTION 0 Type of machine: 0 – ANL,1 – ANLI, 2 – ANR/ANF/SRP, 3 – ANL-C 1 Type of inverter machine 0=longertek 1=APY 2 NTC1 input (TUA) (SIW) 3 NTC2 input (TIA) (SUW) 4 NTC3 input (TSB) (SS) 5 NTC4 input (TGP) (SGP) 6 NTC5 inpu…

19, 53 GB 6343841_00 / Ver - 4.20 Setting heating FORCE-OFF Index - String MIN value MAX value Parameter function j j 30°C 70°C The heat pumps check the working temperature (input or output), to which a safety thre- shold is connected, and beyond which the compressor is switched off imme…

32, 66 GB 6343841_00 / Ver - 4.20 ADDRESS DESCRIPTION 64 NOT USED 65 Fault condition pre-alarm (APY) 66 NOT USED 67 NOT USED 68 Reverse cycle valve pre-alarm 69 Pre-alarm for high water inlet temperature 70 Pre-alarm for reverse cycle due to high discharge gas temperature 71 NOT USED 72…

33, 67 GB 6343841_00 / Ver - 4.20 ADDRESS DESCRIPTION 111 Alarm for IPM protection error (longertek) 112 Alarm for EEPROM error (longertek) 113 Alarm for compressor stalling (longertek) 114 Alarm for absence of communication (longertek) 115 PFC module alarm (longertek) 116 Alarm for …

26, 60 GB 6343841_00 / Ver - 4.20 ELECTRIC HEATER menu To access the ELECTRIC HEATER menu, press the key in (Fig.14). Once the key has been pressed, you must insert the password to access the various menus; to access the user menu, the password is 001. To modify the value of the pas- swor…