AEMC 6255 Operation & User’s Manual

49, LIMITED WARRANTY Your device is warranted to the owner for a period of two years from the date of original purchase against defects in manufacture. This limited warranty is given by AEMC ® Instruments, not by the distributor from whom it was purchased. This warranty is void i…

22, 4.2.9. Selecting the Metal Type (nEtA) 1. Turn the rotary switch to the SET-UP position. 2. Press the ▲ button until “nEtA” appears on the top line of the display. 3. Press the ► button to toggle through the choices of Copper (Cu), Aluminum (Al) or Other Metal. With each press of…

45, 8.2. Measuring Resistance on Electric Motors For this test, Kelvin probes should be used (Figure 8-2). Make contact with each segment on the motor commutator. Allow approximately two seconds for the display to stabilize. Figure 8-2 8.3. Battery Strap Measurements Proper b…

37, 5. MEMORY/PRINTING 5.1. Managing and Printing the Data in Memory The memory is organized into locations called Objects and Tests. There are 99 objects, each containing a maximum of 99 tests (measurements). The maximum number of measurements that can be stored is approximately 1500. A…

12, AEMC 6255 Memory utilization indicator mV m Ω Units of measure Resistive material test mode selected Inductive material test mode selected AUTO Repetitive test mode selected ST BY System idle ready to start a test OPER Test in process Second function of a but…

27, 4.3.2. Test Lead Connection The measurement leads are connected using the four binding posts on the left side of the front panel as shown in Figure 4-3. Connect the two red leads to terminals C1 and P1. Connect the two black leads to terminals C2 and P2. Any drop in the voltage on the…