Neopost DS-35 Installation And Setting Manual

1, 1 ENGLISH Before you start 1. Make sure that the system is suitable for the local mains voltage. Refer to the type plate. 2. The power connection must be easily accessible. Place the system near a socket outlet with protective earth connection. Unpacking instructions 1. Slide the foam blocks …

2, Neopost DS-35 2 Install the feeder block 1. Hold the feeder block slightly inclined as shown in the figure. 2. Lower the block until the grips click on the pins. 3. Rotate the feeder block until it clicks on the system. …

3, 3 ENGLISH 4. Install the four document supports on the feeder trays. 5. Connect the connector. 6. Install the two paper guides LH and two paper guides RH on the feeder trays. Install the envelope catch tray To install the envelope catch tray: 1. Hold support A inclined and slide …

4, 4 Fill the sealing liquid reservoir When you want to seal envelopes, the sealing liquid reservoir must be filled. 1. Open the system with the button on the left side. 2. Lift the sealing liquid reservoir D with the blue handles A carefully out of the system. 3. Remove the strip C from th…

5, 5 ENGLISH Test the system 1. Load the document feeder trays. 2. Load the envelope hopper. 3. In the home menu, press the (new job) button. 4. Configure the job to feed a sheet from every feeder. 5. Press the 1x button. If necessary adjust address position, insert position …