Dialighting LED-PAR64-3W-RGB Operation & User’s Manual

2, General Instructions: Please carefully read and understand the instructions in this manual thoroughly before attempting to operate this unit. These instructions contain important safety information regarding the use and mainte nance of this unit. Please keep this manual with …

3, *Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience recep- tacles, and the point where they exit from the appliance. *Cleaning -The fixture …

4, Data Cable (DMX Cable) Requirements (For DMX and Master/Slave Operation): The PAR CAN can be controlled via DMX-512 protocol. It is a 4/7 channel DMX unit. The DMX address is set below the dome of this PAR light.Your unit and your DMX controller require a standard 3-pin XLR co…

5, 1 3 2 Terminationreducessignalerrors and avoids signaltransmission problemsand interference.lt is always advisadleto connect a DMX terminal,(Resistance120Ohm 1/4W)between PIN2(DMX-)and PIN3(DMX+)of the last fixture . Special Note: Line Termination: When longer runs of cable are used, you ma…

6, Dialighting LED-PAR64-3W-RGB Shnd -This will let you set unit as a master or slave in a master/slave configuration. 1. Tap the MENU button until ¡SLnd¡ is displayed, press ENTER. Either ¡NASe¡¡SL 2¡¡SL 1¡ 2. Tap the UP or DOWN buttons until your desired setting is displayed, …