GBC Velobind System One Operation & User’s Manual

7, 4.0 OPERATING INSTRUCTIONS 4.3 Binding 1. Begin the binding process by pulling the pressure bar toward you and lowering it on top of the document. The indicator light will illuminate. 2. Pull the handle down in a uniform, smooth motion and leave it down. (Don't apply pre…

4, 3.0 INSTALLATION PROCEDURE 3.1 Unpacking Instructions To unpack the machine, carefully remove the staples and open the carton. Remove the packing material from the top and around the machine, and lift the machine straight up out of the carton. Place the machine on a table ne…

3, 2.0 SPECIFICATIONS DESCRIPTION: Punch/Binder PUNCH CAPACITY:* 1/8 in. (3.2 mm) X 14 in. (355.6 mm) 25 sheets of 20 lb. bond paper *Note: No more than 4 composition covers, or 3 plastic covers should be punched at one time. Punching stacks of these …

6, GBC Velobind System One 4.0 OPERATING INSTRUCTIONS 4.2 Document Assembly 1. Check the bind edge guide alignment by inserting a receiving strip in the strip recess area. Lay a sheet of correctly aligned punched paper on the strip, matching up the holes and the strip so that the strip is not showing at the top …

5, 4.0 OPERATING INSTRUCTIONS 4.1 Punching 1. Adjust the punch edge guide to the correct paper length. Check the punch alignment by punching a sheet of paper and folding it in half along the punched edge (See Figure 4-1). Match the holes up: if the corners of the paper match…