Rear view safety RVS-350P Operation & User’s Manual

7, Normal Alarm(ON) Alarm release(Normal) 4.2V 0V(GND) Signal is used for: For GPS vehicle management system (AVL), vehicle operating records systems. The systems receives the RVS-350P signal and can send information in real-time to the management center; can record the signal by on-board…

4, including under the strong light, or for drivers wearing glasses, the distance should be between 60cm-70cm. Usually the distance is between 70cm to 80cm. 8. Sit in the normal driving position. If the green light is on/blinking, this indicates that the driver has been detect…

3, Rear view safety RVS-350P  While every effort has been made to ensure that the information contained in this guide is accurate and complete, we assume no liability for any errors or omissions.  We reserve the right to change the specifications of the hardware and software described herein at anytime witho…

5, ON 1 2 3 4 The volume can be changed by adjusting the switches (DP-4). Notes: (3A) 3A: DIP4=OFF (down), high volume. DIP4=ON (up), low volume. After adjusting the DIP sensitivity switch, the settings will only take effect once the system is disconnected and re-connected. A…

6, RVS-350P Video Output The RVS-350P has an aviation video socket, which can output NTSC video signal (We can also customize PAL signal) 4 pin aviation video socket  The RVS-350P power input range is 9V-32V. It works with both 12V and 24V power  Driver Fatigue Monitor System ha…

2, Product Composition *RVS-350P includes the host and 5 pin signal line. It can work on all types of vehicle, both 12V and 24V power supply. Caution  Do not attempt to disassemble or alter any part of the equipment if you are not authorized professional  Do not adjust system while driving…