rauland 2524 Installation Manual

19, FAST ADVANCE MOTOR 1 RUN ’ MOTOR ; 1 RPM I 59TH MINUTE I I I I I I I I I I I I I I SECONDARY CLOCK is activated for 59 minutes, 6 seconds To (X+1):58:05. ‘Y’ is activated for 54 seconds every hour Not Applicable * See “Correctable …

5, rauland 2524 2524 Master Clock Installation Separate Telecenter@ Systems i . . . . The 2524 can be wired to a Telecenter system and cause the latter to send the tones. In this arrangement, the Telecenter software defines the zones. Telecenter V systems have eight zones…

40, 2524 Clock and intercom Controller Jumpers -!7- PROGRAMMING -\ J3 r- - - -1 ENABLE I DISABLE JUMPER I BAUD - RATE I SELECTOR …

27, -COMMON I I I I +24VDC I I : CORR. ICOIL IMPULSE COIL 2524 I I I I I I I I I I I I I I I I -s---ww- I SECONDARY CLOCK Hourly Correction Timing Minute Impulse “X" is activated for 2 seconds every minute From X:XX:58 To X:XX:00. Except for th…

16, 120/24 VAC RUN MOTOR 120/24 VAC 0 2524 I 120/24 VAC I CORR COIL I I I -------#mm SECONDARY CLOCK Correction Code (Mode A) Correction Timing 12-Hour #08 “Y" is activated for 55 seconds 'Y’ is activated on and off 12 times (65 se…

2, 2524 Master Clock Installation General Information Description The Rauland 2524 combines the full features of a master clock with intercom-control ability. As a master clock, it can correct virtually any secondary clocks and control up to 350 “events” (such as ringing bells or …