Tait TB8100 Installation Manual

11, Tait TB8100 TB8100 Installation Guide Installation 11 © Tait Electronics Limited June 2005 1.8 Installing the Base Station System Caution A TB8100 subrack complete with modules can weigh up to 28kg (62lb), or up to 30kg (66lb) com- plete with packaging. We recommend that, once the equipment …

25, TB8100 Installation Guide Connection 25 © Tait Electronics Limited June 2005 port switch) and modem or radio modem. Refer to TN-906 for more details on using an APS with TB8100 base stations. 2.4 Service Kit Connections The TB8100 Service Kit is connected to the BSS via the RS-232 serial …

19, TB8100 Installation Guide Connection 19 © Tait Electronics Limited June 2005 the rear of the PA. Connect the other end to the auxiliary DC input connector d at the rear of the reciter. Note If you are using an older reciter with a 4-way connector, you will need to use Method 2. 2. …

8, 8 Installation TB8100 Installation Guide © Tait Electronics Limited June 2005 1.7 Ventilation Always ensure there is adequate ventilation around the TB8100 BSS. Do not operate it in a sealed cabinet. You must keep the ambient temperature within the specified range, and we strongly reco…

4, 4 Installation TB8100 Installation Guide © Tait Electronics Limited June 2005 1.1.3 Proximity to RF Transmissions Do not operate the transmitter when someone is standing within 90cm (3ft) of the antenna. Do not operate the transmitter unless you have checked that all RF connectors are secure…

16, 16 Connection TB8100 Installation Guide © Tait Electronics Limited June 2005 2 Connection 2.1 Auxiliary Power Supply Connections PMU Auxiliary DC Output The PMU can provide an auxiliary DC output when it is fitted with the optional auxiliary power supply board. This board is availa…