RS SAILING RS Neo Rigging Manual

45, 43 Reef To make the sails smaller in strong winds Retaining Pin On a trolley, to hold the launching trolley to the road base Road Base A trolley that you place your boat and launching trolley upon to …

28, RS SAILING RS Neo 26 Now you are almost ready to go Neo sailing. All that is left to do is: • Fit the rudder to the back of the boat • Check that all the knots and shackles are tied securely. …

2, Contents 1. Introduction ............................................................. 1 2. Technical data ......................................................... 2 3. Commissioning ....................................................... 3 - 24 3.1 - Preparation ..............................…

18, 16 B B A A q) r) s) When pulled tight blocks should be 60mm apart. Before sailing hoist the sail and make nal adjustments. You may need to adjust it again after the rope has stretched. VANG CONTROL LINE A A B B C C D D E Note: The control line is tapered at one end. This end will remain in the…

33, 31 6.1 - Boat Care The RS Neo is made using Comptec PE3, a three-layer polyethylene construction. This is stiff and light, but will dent if subjected to point loading. The boat should be supported ashore on an approved RS trolley, as the hull may distort if not supported properly. For…