Sandel sn3500 ehsi Installation Manual

71, Appendix A: Post-Installation Procedures 7.1.10 Page 10: OBS / RELAY / CDI Configuration Field Options Comment OBS ROT NORMAL REVERSED DIFF A Adjusts rotation of OBS. Select DIFF A when interfaced to 400HZ differential resolver. BTSTRP NONE NORMAL REVERSE…

101, Sandel sn3500 ehsi Appendix E: Checkout Procedures COMPANY NAME COMPANY ADDRESS TELEPHONE/FAX Flight Test Procedures/Report for Sandel Avionics SN3500 Installed in {aircraft make and model} Registration No. ________ Serial No. ______________ Document N…

7, Revision Date Comments J 05/27/10 Updated for software version 4.02 AR1110. Corrected TOC Section 3.3.2: Updated P2-3/35 pin description and added note for composite LOC DEV calibration procedure. Section 7.1.2: New TACAN Relay out pin configuration. Section 7.1…

57, Appendix A: Post-Installation Procedures Reversionary Attitude Configuration (ARINC 429 Low/High speed only) When the HEADING source is configured as ARINC 429, an optional Reversionary Attitude Mode is available for activation via a valid key entry. Once configured and valid, T…

89, Appendix E: Checkout Procedures COMPANY NAME COMPANY ADDRESS TELEPHONE/FAX Ground Test Procedures/Report For Sandel Avionics SN3500 Installed in {aircraft make and model} Registration No. ________ SN3500 Serial No. ______________ Document No. ____…

90, Appendix E: Checkout Procedures 11.1.1 Introduction The following ground test procedures are to be performed after the SN3500 has been properly configured in the “Post-Installation Procedures”, but prior to performing flight test procedures. Successful completion of both…