Movincool OFFICE PRO 12 Operation Manual

22, Movincool OFFICE PRO 12 22 OPERATION (cont.) How to View and Delete Program 1. Press and hold the SET PROG button for 3 seconds or until beep. 2. To view edited program - While pressing and holding the SET PROG button, press SET TEMP buttons ( / ) to scroll program sequence. 3. To delete a program - Press ENTER …

19, 19 OPERATION (cont.) Set Clock Prior to operating the Office Pro 12, Office Pro 18, or Office Pro 24 users should set the clock of the controller to the correct time as shown in the following steps: 1. Press and hold the SET CLOCK button for 3 seconds or until beep. (LCD indicates blinkin…

12, 12 INSTALLATION (cont.) Warning Signal Connection (Output Signal Terminal L+ and L-) The controller is equipped with a warning signal output relay type (Form C, normal open dry contact) which can be used to monitor the failure condition. Relay contactor is closed when the following condition …

14, 14 INSTALLATION (cont.) LCDI Power Cord Instruction WARNING CAUTION Procedure <FRONT VIEW> The LCDI device is a non-serviceable device. Attempting to open the device may expose the user to the hazards of electric shock, and could void warranties of this product. Manufacturer’s rel…

17, 17 OPERATION (cont.) Control Panel (cont.) LCD Indicators Note: ROOM TEMP display range is from 16 °F to 109 °F (-9 °C to 42 °C). When the display value is greater than 99 °F, it displays values of +0F (for 100 °F), +1F (for 101 °F) and +9F (for 109 °F). (This only applies to Farenh…

10, 10 INSTALLATION (cont.) Plugging in the Unit 1. Check the prongs and surface of the power cord plug for dust/dirt. If dust and/ or dirt are present, wipe off with a clean, dry cloth. 2. Check the power cord, plug and prongs for damage or excess play. If any damage or excess play is found, contact …