RKI Instruments Beacon 200 Operator's Manual

20, 20 • Wiring the Beacon 200 Gas Monitor 4. Locate the 2-point AC In terminal strip (see Figure 1). The terminals are labelled LINE and NEUT. 5. Guide the AC power cord or wires through the right-most conduit hub on the bottom of the Beacon 200 housing. CAUTION: Do not route power and…

56, 56 • Parts List Parts List The table below lists the part numbers and descriptions for replacement parts and accessories offered for the Beacon 200 Gas Monitor. Table 12: Parts List, Beacon 200 Gas Monitor Part No. Description 18-0107RK Conduit Hub (3/4 in.) 43-0440RK Reset S…

42, RKI Instruments Beacon 200 42 • Setting Up a New Channel or Changing an Existing Channel Setting Up a New Channel or Changing an Existing Channel 1. While the Beacon 200 is off, press and hold the ENTER button, then turn on the Beacon 200 with the ON/OFF switch. 2. The Beacon 200 will beep repeatedly whil…

55, Troubleshooting • 55 Flickering Display • The display readings flicker often. • The Beacon 200 is experiencing false readings due to RFI or EMI. • The noise filter setting is too low. • The zero suppression setting is too low. • The display screen is malfunctioni…

29, Recorder Output Operation • 29 Recorder Output Operation The output at the recorder output terminals is a 4 - 20 mA signal for each active channel that is proportional to the detection range of the channel. A channel that is set as CHANNEL NOT USED or CHANNEL DISABLED in the Channel Control …

2, ii • Product Warranty Product Warranty RKI Instruments, Inc. warrants gas alarm equipment sold by us to be free from defects in materials, workmanship, and performance for a period of one year from date of shipment from RKI Instruments, Inc. Any parts found defective within…