Novatel WAAS G-III Operation & User’s Manual

126, 126 WAAS G-III Reference Receiver User Manual Rev 1 Chapter 5 Data Logs Table 50: TRAIM Status Nibble Bit # Description Range Value N 0 0 a a. If bit 0 is cleared, the residual was used to attempt to compute the clock offset. If bit 0 is set, one or more of bits 3-31 are set indicati…

68, 68 WAAS G-III Reference Receiver User Manual Rev 1 Chapter 4 Commands 4.4.18 RESET This command performs a hardware reset. Following a RESET command, the receiver re-enters the BOOT state. Valid Stat es: Maintenance, Configuration, Operational Valid Mode s: Normal, Failed Acc…

83, Commands Chapter 4 WAAS G-III Reference Receiver User Manual Rev 1 83 4.4.32 UNLOG This command removes a specific log request from the system. Valid Stat es: Configuration, Operational, Maintenance Valid Mode s: Normal, Failed Acceptable Ports: Data Syntax: UNLOG [port] message…

121, Novatel WAAS G-III Data Logs Chapter 5 WAAS G-III Reference Receiver User Manual Rev 1 121 5.5.16 RXCOMMANDSB This log contains the current receiver configuration parameters set either by default or by user issued commands. Each command may be included multiple times since they configure different signa…

20, 20 WAAS G-III Reference Receiver User Manual Rev 1 Chapter 1 Introduction Table 2: Data Communication Ports Label Description J02 DATA Data port An Ethernet port used to configure the G-III Reference Receiver and collect data from the receiver. In a typical installation, this port c…

91, Data Logs Chapter 5 WAAS G-III Reference Receiver User Manual Rev 1 91 5.3 Functional Listing of Logs The following tables list the logs by function. Table 31: Measurement Data Logs Log Description ALLSQMIB Contains SQM data for I correlators. Legacy Log. ALLSQMQB Contains SQM…