Teeter FitSpine R.E.D. Assembly Instructions Manual

12, Step 9 Figure 19 Figure 17 Attach the Angle Tether ™ (F5-1007) to Limit the Degree of Rotation • The Angle Tether ™ will come pre-assembled to the A-Frame. • Unfold the adjustable Angle Tether ™ and clip it to the U-Bar on the underside of the Table Bed (Figure 17). Attach…

8, Install the Roller Hinges (F5-1064) onto the Table Bed (EP-1300) • For ease-of-assembly, rest the Table Bed against the Crossbar of the A-Frame (Figure 4). • Open the Cam Locks on each side of the Table Bed (Figure 5). • With the Pivot Pins facing outward, insert the Roller Hinges int…

2, Teeter FitSpine R.E.D. IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THE INVERSION TABLE. WARNING ! SAVE THESE INSTRUCTIONS WARNING - To reduce the risk of injury to persons: • Read and understand all the instructions, view the Instructional DVD, review all other accompanying documents, a…

3, NX-1110 F5-1007 Hinge Covers (2) Hex Bolts (4) Hex Bolts may come pre-assembled in handles 3-Hole Roller Hinge (2) Wrenches 5 mm Allen Wrench 10/13 mm Wrenches (2) FS-1045 NX-1650 IA-1148-B Bolts/Nuts may come pre-assembled in handles Items are not shown to scale. If you have any qu…

7, 1 2 Attach the Upper Support Arms to the Table Bed (EP-1300) • Place the Table Bed face down on the floor and push down on the Support Beam, so the two holes align evenly with the holes at the base of the Upper Support Arms (Figure 2). You may have to exert extra pressure to…